Cmd.
Sub
cmd.
Data Description
1C 00 00 Send/read transceiver’s status (RX)
When “CI-V Output (for ANT)” (Command:
1C 04) is set to “ON,” automatically outputs
when changed.
01 Send/read transceiver’s status (TX)
When “CI-V Output (for ANT)” (Command:
1C 04) is set to “ON,” automatically outputs
when changed.
01 00 Antenna tuner OFF (through)
01 Antenna tuner ON
02 Tuning
02 00 Send/read transmit frequency monitor setting
OFF
01 Send/read transmit frequency monitor setting
ON
03 see p. 166 Read transmit frequency
When “CI-V Output (for ANT)” (Command:
1C 04) is set to “ON,” automatically outputs
when changed.
04 00 Send/read command to disable to output the
antenna controller status (frequency and so
on) from [REMOTE].
01 Send/read command to enable to output the
antenna controller status (frequency and so
on) from [REMOTE].
1E 00 Read number of available TX frequency band
01 see p. 168 Read TX band edge frequencies
02 Read number of user-set TX frequency band
03 see p. 168 Send/read user-set TX band edge
frequencies
21 00 see p. 168 Send/read RIT frequency
01 00 Send/read RIT setting is OFF
01 Send/read RIT setting is ON
02 00 Send/read ∂TX setting is OFF
01 Send/read ∂TX setting is ON
25 see p. 168 Send/read the Main or Sub band frequency
26 see p. 168 Send/read the selected operating mode and
filter
Command table (continued) D
To Next Page
Loading...
