What to do if repeater cannot be accessed on Icom IC-7600 Transceiver?
To access a repeater with your Icom Transceiver, first ensure the split frequency function is activated by pushing [SPLIT] to turn it ON. If it still doesn't work, the programmed subaudible tone frequency may be wrong; reset the frequency using set mode.
Why is transmitting impossible on my Icom Transceiver?
If your Icom Transceiver is not transmitting, make sure that the operating frequency is within a ham band. If it is not, set the frequency to be in a ham band.
General| Antenna Connector | SO-239 |
|---|---|
| Supply Voltage | 13.8 V DC ±15% |
| Frequency Coverage | 0.03–60 MHz |
| Modes | SSB, CW, RTTY, AM, FM |
| Receiver Type | Superheterodyne |
| Display | TFT LCD |
| Weight | 12 kg |
| Type | HF Transceiver |
| Receiver Sensitivity | 0.16 µV |
| Image Rejection Ratio | >70 dB |
| IF Rejection Ratio | >70 dB |
| Audio Output Power | 2.5 W at 10% distortion |
| Intermediate Frequencies | 64.455 MHz, 455 kHz |
| Selectivity | SSB: 2.4 kHz |
| Current Drain | 2.5 A (receive) |
To Next Page
