IDEC SmartRelay functions
203
IDEC SmartRelay Manual
Changing parameters in the active message text
You can allow editing of parameter and process variables in
an active message text by entering a “+” in the first line. To
prevent changes, enter a “-” sign.
When the message text is active, press ESC to select the ed-
iting mode.
Note
You must keep the ESC key pressed at least for one second.
Press
▲
and
▲
to select the relevant line (you can only se-
lect lines that contain parameters). Press OK to change the
parameter. Use the keys
▲
,
▲
, ▲ and ▼.
Confirm your changes with OK. You can now edit further pa-
rameters in the message text (if any exist). Press ESC to exit
editing mode.
Key input simulation in the active message text
You can enable the four cursor keys C▲, C
▲
, C▼ and C
▲
in an active message text by pressing ESC plus the relevant
cursor key.
Analog value monitoring ∆, A, B, Ax, Aen
Analog amplifier A, B, Ax
Analog multiplexer V1, V2, V3, V4, AQ
Analog Ramp Control L1, L2, MaxL, StSp, Rate, A, B,
AQ
PI controller SP, Mq, KC, TI, Min, Max, A, B,
PV, AQ
Miscellaneous
Latching relay -
Current impulse relay -
Message texts -
Softkey On/Off
Shift register -
Special function Parameter or process vari-
able visible in a message text
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...