IDEC SmartRelay FL1D Series - Page 225

IDEC SmartRelay functions
215
IDEC SmartRelay Manual
Parameter p (number of decimals)
Applies only to the values displayed in a message text.
Timing diagram
Functional description
If input En is set, then the function issues one of 4 possible
analog values V1 to V4 at the output AQ, depending on the
value of S1 and S2.
If the input En is not set, then the function issues the analog
value 0 at output AQ.
Analog output
If you interconnect this special function with a real analog
output, note that the analog output can only process values
between 0 and 1000. To do this, you may need to connect
an additional amplifier between the analog output of the
special function and the real analog output. Using this
amplifier, you standardize the output range of the special
function to a value range of 0 to 1000.
En
SS1
S2
AQ
V1
V3
V2
V4
0
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com