idp SMART-81 - Page 25

25
>>LAM Serial Cancel Information
Menu -
Information
Menu +
x Check
Information
Display Laminator serial
number.
>>PRN Firmware Cancel Information
Menu -
Information
Menu +
x Check
Information
Display Printer firmware
version.
>>LAM Firmware Cancel Information
Menu -
Information
Menu +
x Check
Information
Display Laminator
firmware version.
>>Factory Count Cancel Information
Menu -
Information
Menu +
x Check
Information
Display Factory Count.
xxxx
>>User Count Cancel Information
Menu -
Information
Menu +
x Check
Information
Display User Count.
xxxx
>>Print Sample Cancel Information
Menu -
Information
Menu +
Sample
Image print
Check
Information
Print sample image.
Press Enter Key!
>>LCom RCom Cancel Information
Menu -
Information
Menu +
Communica
tion
recovery
count Clear
Check
Information
LCom : Communication
with Laminator recovery
count clear, RCom :
Communication with ext
hopper recovery count
clear
xxxxxx xxxxxx
>FBlk Mrev Lcin Cancel Information
Menu -
Information
Menu +
Recovery
count Clear
Check
Information
FBlk : movement retry
count during jam Flipper-
>Printer transfer
Mrev : retry count
during Laminator to
Command transfer.
Lcin : count of movement
recovery that move from
Laminator(receive data
from Laminator)
xxxxx|xxxxx|xxxx
SMART-81x x x x x MagRead/Writ
e
Magnetic Card
Reading/Writing.
Mag R/W
SMART-81x x x x x Printing Printing
Printing
SMART-81x x x x x Printing Retransfer heating.
Heating
SMART-81x x x x x Printing Retransferring
Retransferring
SMART-81x x x x x Laminating Laminating.
Laminating
Board Test Mode x x x x Test mode Test mode for test
function of Smart81’s
Sensor/Motor.
Wait
RibbonNotFound Retry
Ribbon
recognize
Retry
Ribbon
recognize
Retry
Ribbon
recognize
Retry
Ribbon
recognize
Ribbon
recognize
error
Ribbon recognize error,
ribbon is not installed or
mis-recognize, press key
to retry ribbon recognize
Check Ribbon
Ribbon Not Found Retry Retry Retry Retry Ribbon If the ribbon and print