idp SMART-81 - Page 27

27
key to start the ribbon
rescan.
Check Please.. Ribbon &
Film
research
Ribbon &
Film
research
Ribbon &
Film
research
Ribbon &
Film
research
Film Zero There is no film
remaining. film must be
replaced. Press the key to
start the film rescan.
Film Zero
Check Please.. Ribbon &
Film
research
Ribbon &
Film
research
Ribbon &
Film
research
Ribbon &
Film
research
Ribbon &
Film zero
There is no Ribbon & film
remaining. Ribbon & film
must be replaced. Press
the key to start the
Ribbon & film rescan..
Rib & Film Zero
SMART-81x x x x x Firmware
update
Printer Firmware Update
is in progress. Display as
“%”.
Power Must Not be
turned off until
automatically rebooted.
Printer xxx%
SMART-81x x x x x Firmware
update
Lamintor Firmware
Update is in progress.
Display as “%”.
Power Must Not be
turned off until
automatically rebooted.
Laminator xxx%
Update Fail System
Reset
System
Reset
System
Reset
System
Reset
Firmware
update
Error occur while Printer
Firmware Update. Press
the key to System Reset.
PushAnykey Reset
Do Prt Clean! MENU Information
Menu -
Information
Menu +
x Cleaning
warning
(Ready)
It is displayed when
Cleaning Count is 5000 or
higher, and Card Printer
Config Utility program -
Cleaning Warning is
“Notice”.
Message disappears
Cleaning Count is over
5200.
Except message display, it
is same as system ready
state
System Ready
Do Prt Clean!! MENU Information
Menu -
Information
Menu +
x Cleaning
warning
(Ready)
It is displayed Cleaning
Count 5000 or higher,
and Card Printer Config
Utility program - Cleaning
Warning is “Permanent”
Message continues to be
displayed until the
cleaning is performed.
Except message display, it
is same as system ready
state
System Ready
Cleaning Mode x x x x Cleaning
mode
Cleaning mode
initializing.
Initializing