idp SMART-81 - Page 63

63
Retransfer: tab showing the retransfer setting value.
Retransfer: Front Card
Position
card position when start retransfer (Front)
Retransfer: Back Card
Position
card position when start retransfer (back)
Retransfer: Operation
Temperature
Retransfer temperature
Retransfer: Standby
Temperature
Retransfer heater Standby temperature
Retransfer: Heating
Trigger Temperature
Heating trigger temperature when printing panel
Retransfer: Former
Heating Control
Heater operation cycle when retransfer (former)
Retransfer: Latter
Heating Control
Heater operation cycle when retransfer (latter)
Retransfer: Total Length
Retransfer operating Total length
Retransfer: Start Delay
Retransfer head down standby time when retrnasfer
Retransfer: Pre Film
Loosen Length
Wrinkle value when retransfer (head up)
Retransfer: Pre Film
Retraction Length
Wrinkle value when retransfer (head down)
Retransfer: Speed
Retransfer speed (Head Down)
Retransfer: Film/Roller
Rate
Film ribbon separate length when retransfer
Post Retransfer: Speed
Retransfer speed (Head Up)
Post Retransfer:
Film/Roller Rate
Film-motor speed rate when retransfer (Head Up)
Final Retransfer: Length
Film lint protection c overage
Final Retransfer: Speed
Retransfer speed (film lint protection)
Bend Remedy: Operation
Temperature
Bend remedy heater operation temperature
Bend Remedy: Standby
Temperature
Bend remedy heater standby temperature