idp SMART-81 - Page 64

64
Extra: Tab showing other setting values
Card In Speed Card in speed
Card Out Speed Card out speed
Card Move Speed Card move speed(inside printer)
DCL Mode DCL mode
SBS Only Only SBS commend mode
Dump Mode Dump mode
Card Out Card out direction
Error Card Out Error card out direction
Auto Front Card In Auto card in with sensor detection (machine front)
Auto Rear Card In Auto card in with sensor detection (machine rear)
Cleaning Warning Machine Cleaning warning
Fan PWM Control Fan PWM control Setting
Flipper Cover Open Ignore machine left cover open Setting
Mag. Write Speed MS write speed Setting
Separation Mode Method of Separate ribbon and film Setting
Print Heat Retransfer heater heating during printing setting
PrintHeat Condition Temperature check when Print Heat Setting
Heat after Boot Whether to operate the heater immediately after booting Setting
Heat Bend in BOTH Whether to operate both side Bend remedy heater Setting
Display TYPE LCD type Setting
Display Language LCD display language Setting
LCD Backlight LCD backlight Setting
Cartridge Open Check card-in stacker cartridge installation is installed
Card In Walt Heating Whether to heating when card in
Security. PC Auth. Whether PC Authentication mode setting
Security. User Auth. Whether to use user password Setting
Security. Root Auth. Root password Setting
User MS W. Current MS write output Setting
MS Write Mode MS write use mode Setting
MS Write Start MS write start position Setting
Card In Delay DC motor operate time after card in
Use USB Serial
Whether to use the printer’s serial number as the USBdevice
serial number
Cooling Temperature Cooling fan operating reference temperature
Builtin Hopper Whether to use builtin hopper
External Hopper Select external hopper
Retransfer Heater
Standby Time
Retransfer heater standby time for next print
Color Sensor
Calibration
Color sensor calibration