idp SMART-81 - Page 85

85
Printing Err
Error occurs while printing
-. Check a card is jammed
-. Check usage of a genuine ribbon and cards
-. Check the rollers, encoders and cards, and clean them if they are polluted
Ribbon Seek Err
The printer can’t search the ribbon panel in printing or booting up
-. Check the operating state of the Ribbon Motor
-. Check the operating state of the ribbon encoder sensor and gears
-. Check and clean the Color In/Out Sensor
-. Check the operating state of the color in/out Sensor
-. Check the ribbon is tightly installed inside the printer
Ribbon Move Err
The printer can’t wind the ribbon in printing or booting up.
-. Check the operating state of the Ribbon Motor
-. Check the operating state of the ribbon encoder sensor and gears.
-. Check the ribbon is tightly installed inside the printer
Film Search Err
Error occurred while recognizing film location
-. Check the operating state of step motor and DC motor
-. Check the film position sensor.
-. Check the ribbon is tightly installed inside the printer.
Film Move Err
Error occurs while driving the film motor.
-. Check the operating state of step motor and DC motor
-. Check the ribbon is tightly installed inside the printer.
Head UpDown Err
Error occurs while head module(Thermal head, retransfer head) move up/dwon
-. Check Head Up/down sensor.
-. Check the operating state of head motor.
Heater Error
Retransfer Heater is overheated.
-. Check the thermistor is properly attached to the heater
-. Lower the temperature when the temperature of circumstance is too high
-. Take a stop for 10 minutes and print again.
-. Contact the place of purchase if this message is shown regularly
.
Bheater Error
BandHeater is overheated.
-. Check the thermistor is properly attached to the heater
-. Lower the temperature when the temperature of circumstance is too high
-. Take a stop for 10 minutes and print again.
-. Contact the place of purchase if this message is shown regularly.
TPH Overheat
Thermal Print Head is overheated
-. Lower the temperature when the temperature of circumstance is too high
-. Take a stop for 10 minutes and print again.
-. Contact the place of purchase if this message is shown regularly