idp SMART-81 - Page 86

86
IC UpDown Err
The IC Head Up/Down Motor or Sensor don’t work correctly in printing, encoding or
booting up.
-.
Check the state of the Cable between a module and a main board
-. Check the operating state of the IC Motor
-. Check IC Up/Down sensor
Solenoid Err
Error occurs while printer Lock solenoid operating
-. Check the wire of solenoid module
-. Check the operating state of Solenoid.
-. Check Printer Lock sensor.
MAG R/W Err
Fail to read or write the magnetic strip.
-. Check the surface and direction of magnetic card
-. Check the coercivity of magnetic card and encoding configuration
-. Check the rollers, encoder and cards, and clean them if they are polluted
-. Check the magnetic head and clean if it is polluted.
MAG T1 Err
Fail to read a track 1 of the magnetic strip.
-. Check the surface and direction of magnetic card.
-. Check the coercivity of magnetic card and encoding configuration.
-. Check the rollers, encoder and cards, and clean them if they are polluted.
-. Check the magnetic head and clean if it is polluted
MAG T2 Err
Fail to read a track 2 of the magnetic strip.
-. Check the surface and direction of magnetic card.
-. Check the coercivity of magnetic card and encoding configuration.
-. Check the rollers, encoder and cards, and clean them if they are polluted.
-. Check the magnetic head and clean if it is polluted
MAG T3 Err
Fail to read a track 3 of the magnetic strip.
-. Check the surface and direction of magnetic card.
-. Check the coercivity of magnetic card and encoding configuration.
-. Check the rollers, encoder and cards, and clean them if they are polluted.
-. Check the magnetic head and clean if it is polluted
ConExtDeviceErr
Error occurs while the printer is communicating with the laminator
-. If the laminator is installed, please check laminator is powered.
-. Check the communication status between the printer and the laminator.
Ribbon None
ribbons are not installed
-. Install the new ribbon after purchasing it in the place of purchase.
-. Check usage of a genuine ribbon if ribbon is already installed.
Ribbon Zero
All ribbons are used
-. Install the new ribbon after purchasing it in the place of purchase.
Film None
Film is not installed
-. Install the new Film after purchasing it in the place of purchase.
-. Check usage of a genuine film if it is already installed
Film Zero
All films are used
-. Install the new film after purchasing it in the place of purchase..