idp SMART-81 - Page 87

87
TPH None
Thermal Print Head is not installed or not recognized
-. Check the print head installation
-. Contact the place of purchase.
Heater None
Retransfer heater is not installed or not recognized
-. Check the Retransfer installation
-. Contact the place of purchase.
Bheater None
Band heater is not installed or not recognized
-. Check the Band Heater installation
-. Contact the place of purchase.
Heater Broken
Retransfer’s control circuit or heater not operate
-. Check the Retransfer installation
-. Contact the place of purchase.
Bheater Broken
Bheater’s control circuit or heater not operate
-. Check the Bheater installation
-. Contact the place of purchase
PrintData Fail
Error in print data
-. Replace the USB cable USB
-. Change the USB port in the PC
-. Reinstall the printer driver.
-. Check the options for the print data are correct
Spool Full
The printing data is full in the spooler.
-. This message disappear after printing all data to send
-. Turn off/on the printer if the spool data is full without printing.
Invalid Password
The password is not correct.
-. Input the correct password.
-.
Contact the place of purchase if you forget the password.
Set Fail
Failed to execute a command of the printer
-. Replace the USB cable USB
-. Change the USB port in the PC
-. Turn off/on the printer
Lcd Con Error
Error occurs while control Lcd
-. Please reboot computer.