IEMCA VIP 80 - Interface Parameters - Description

69
3
SETUP INFORMATION
302.061
3.1.4 Interface parameters - Description
Subparameters
It defines how to handle the interface signals from lathe to bar feeder.
85
no.85 Interface s ign
als
Bar change
(0=NO/1=NC) 0
Feed
(0=NO/1=NC) 0
Load i ng c y c l e
(0=NO/1=NC) 1
Ma n u a l / a u t . f r om l a t h
e(0=NO/1=NC)0
Thr e ad i ng s a f e t y
(0=NO/1=NC) 0
Feed s t op
(0=NO/1=NC) 0 (0)
Safety from lathe
(0=NO/1=NC) 1
Start from lathe
(0=NO/1=NC) 0
Startup safety
( 0 =K3 7 / 1 =K1 6 6 ) 1
Do o r s a f e t y
(0=NO/1=NC) 0
Chan g e mm<- ->inches
(0=mm/1=inches)0
Startup start
(0=NO/1=NC) 0