IEMCA VIP 80 - Troubles - Causes - Remedies; General Troubles; Bar Magazine Troubles; Bar Feeding Troubles

- 50 -
302.028
8
TROUBLES - CAUSES - REMEDIES
8.1. GENERAL TROUBLES
Cause
No power input.
Cure
Remedy
Check electric connection.
Cause
The guard is open.
Cure
Remedy
Close guard.
Cause
Emergency devices operated.
Cure
Remedy
Reset emergency devices.
Cause
Motor thermal cutout tripped.
Cure
Remedy
Reset motor overload cutout using
special buttons.
Cause
No lathe signal.
Cure
Remedy
Check electric connection to lathe.
Cause
No air.
Cure
Remedy
Check air system.
Cause
Motor thermal cutout tripped.
Cure
Remedy
Remset the motor overload cutout using
special buttons.
THE FEEDER WILL NOT START
FEEDER IN STARTING STATUS BUT
AUTOMATIC CYCLE WON'T START
THE PNEUMATIC DEVICES DO NOT RESPOND
PREFEEDING AND FEEDING STOP
SUDDENLY
7
8.2. BAR MAGAZINE - TROUBLES
Cause
The magazine covering frame is
too low.
Cure
Remedy
Adjust the position of the covering frame.
Cause
Wrong setting of the bar selector.
Cure
Remedy
Adjust the selector.
Cause
The magazine is not inclined
enough.
Cure
Remedy
Tilt the magazine.
Cause
Wrong setting of the bar selector
and/or of the magazine covering
frame.
Cure
Remedy
Adjust the selector and/or the covering
frame position.
8.3. BAR FEEDING - TROUBLES
Cause
Wrong setting of the guide lifting
limit switch.
Cure
Remedy
Adjust the limit switch.
THE BAR WON'T ENTER MAGAZINE
DURING LOADING
THE FIRST BAR IN THE MAGAZINE IS NOT
LIFTED
THE SECOND BAR IN THE MAGAZINE IS LIFTED
TOGETHER WITH THE FIRST
THE BAR HAS DIFFICULTIES IN ENTERING THE
LATHE SPINDLE