USE AND OPERATION
6
302.028
- 42 -
6.5. FEEDER STOP
CAUTION: After the feeder has stopped, do not move it
manually. Use the push-buttons.
❑
Feeder emergency stop
CAUTION: if the emergency stop is used during lathe
machining, before resuming work make sure that the
sudden stop has not created any hazardous condition
(e.g., if the tool was cutting chips, move the tool away
from the workpiece before restarting the lathe).
To stop the feeder in an emergency, press an emer-
gency push-button, either that of the lathe or that of the
feeder.
❑
Feeder stop at work end
CAUTION: Do not use emergency buttons for normal
machine stop.
– Complete the operations in your work schedule.
– Stop the feeder by pressing the but-
ton.
– Stop the lathe.
6.6. STARTING THE AUTOMATIC CYCLE
FOLLOWING MANUAL CYCLE
OPERATIONS
(fig. 9)
It is the automatic cycle starting following: manual
movements, parameter changes, servicing, etc.
When performing said operations, the lathe is in an
“ALARM" mode, therefore follow the procedure below.
❏
The bar feeder must be in MANUAL mode,
ready to start the automatic cycle.
Set the bar feeder on the "WORK" phase
Press
To Next Page
Loading...
