IEMCA VIP 80 - 2 Installation Procedure; Operator Parameters - Description and Setting

13
302.061
2
INSTALLATION PROCEDURE
2.1. OPERATOR PARAMETERS - Description and setting
Introduction
These parameters concern programming of the bar feeder automatic cycle;
the relative values must be entered on the basis of work requirements and
type of machine to which the bar feeder is connected.
CAUTION: each parameter has a specific default value (preset value). If the ope-
rator does not change these values, the bar feeder performs the automatic cycle
according to them.
INFORMATION: it is not necessary to enter all parameter values; whether they
are to be partially or totally entered depends on the type of lathe or the type of
process adopted.
Some parameters concern the machining phase or the bar change phase.
During the machining phase, the lathe is fed by the bar feeder.
During the bar change phase, the bar feeder carries out the bar change.
❑
Accessing the parameters
Access to data entering
turn the selector:
onto position
recall “MAIN MENU”
press:
it appears:
20
MAIN
*** MEN
U***
5-02-00
12:09:40
(GB) (Par . 0 ) (Co
de 0)
→
)
Mo v e
––––––––––––––––––––
––––––––––––––––––––
date time
language in which
information is displayed
operations that can
be carried out