IEMCA VIP 80 - 4 Information Aimed at the Authorised Technician

1
302.061
INDEX
1
GENERAL INFORMATION
1.1. PUSH BUTTON PANEL - CONTROL DESCRIPTION ........................................................3
1.2 MAIN SCREENFUL - DESCRIPTION..................................................................................8
1.3. DATE AND CLOCK - PROGRAMMING ............................................................................10
2
INSTALLATION PROCEDURE
2.1. OPERATOR PARAMETERS - DESCRIPTION AND SETTING ........................................13
2.1.1 Operator parameters - Description.....................................................................................17
2.2. ERRORS - CAUSES - SOLUTIONS..................................................................................37
2.3. PROGRAMME IDENTIFICATION DATA - DISPLAYING PROCEDURES........................53
3
SETUP INFORMATION
3.1. PROTECTED PARAMETERS FOR SETTING-UP - Description.......................................55
3.1.1 Description of bar feeder phase parameters......................................................................59
3.1.2 Description of reference value parameters ........................................................................62
3.1.3 Axis function parameter description ...................................................................................65
3.1.4 Interface parameters - Description.....................................................................................69
3.1.5 Description of generic parameters .....................................................................................70
4
INFORMATION AIMED AT THE AUTHORISED TECHNICIAN
4.1 PROTECTED PARAMETERS FOR SETTING-UP - ENTERING AND CHECKING..........75
4.1.1 Protected parameters entry mode......................................................................................77
4.2. PROCEDURE FOR ENTERING DEFAULT VALUES IN THE PARAMETER ...................79
REQUEST FOR ASSISTANCE
A LIST OF GENERIC PARAMETERS
B LIST OF BAR FEEDER PHASE PARAMETERS
C LIST OF REFERENCE VALUE PARAMETERS
D LIST OF AXIS FUNCTION PARAMETERS
E LIST OF INTERFACE PARAMETERS
F LIST OF GENERIC PARAMETERS
G HARDWARE IDENTIFICATION DATA
The pages of this paragraph may not be enclosed. The manufacturer reserves the right to spread the infor-
mation contained in this paragraph.
(*)
(*)
(*)
(*)