IEMCA VIP 80 - Operator Parameters - Description

18
2
INSTALLATION PROCEDURE
302.061
2.1.1 Operator parameters - Description
Defines the position of the point at which the bar feeder must
send the "END OF BAR" signal to the lathe.
It is a value referred to point
F
(maximum bar pusher feed
point), and corresponds to the length of the workpiece plus the
thickness of the cutting tool.
Defines the movement of the bar head with reference
to point
C
(facing point).
Both positive and negative values can be entered.
Defines the facing.
1-
“
In position
”; the bar is positioned at the point defined in
parameter 2
.
0-
“
To the stop
”; the bar moves past the point defined in
parameter 2
until
it meets the bar stop or the tool.
1
Phase
machining
:> 100(mm)
( inches )
no.1 Bar end adjustm
ent
IDM - 61.006 Ec.0
Parameter 1
2
Phase
bar change
:> 0(mm)
0(inches)
no . 2 Fac i ng l eng th
C
IDM - 61.007 Ec.0
Parameter 2
(positive value)
Parameter 2
(negative value)
3
Phase
bar change
:>0
no.3 Facing mode