HANDLING AND INSTALLATION
4
- 24 -
302.028
4.7. ELECTRIC CONNECTION
DANGER - WARNING: This type of intervention should
only be entrusted to qualified personnel with specific
skills in accordance with the applicable regulations and
standards.
As a rule, the feeder comes equipped with a multipolar
electric plug to be plugged into the specially provided
lathe socket (check the "Wiring diagram" if needed).
4.8. ADDITIONAL PUSH-BUTTON PANEL -
INSTALLATION
(fig. 21)
The additional push-button panel can be removed from
its housing.
According to working requirements, it can be installed
nearby the lathe push-button panel.
4.9. SELF-LEARNING VALUES - ENTRY INTO
PROGRAM
Self-learning values depend on type and dimension of
the lathe to which the bar feeder has been fitted.
Said operation is necessary, since the bar moves accor-
ding to these values.
For detailed information relevant to this operation, see
the “Push-button panel instruction manual".
To Next Page
Loading...
