TROUBLES - CAUSES - REMEDIES
8
- 51 -
302.028
Cause
Bar passage guide adjustment too
high.
Cure
Remedy
Adjust bar passage guide to right height.
Cause
Feeder not aligned with lathe.
Cure
Remedy
Check and correct alignment.
Cause
The bar is too long.
Cure
Remedy
The max. length must correspond to the
max. length contained in the lathe
spindle.
Cause
Excessive flash at bar end.
Cure
Remedy
Remove bar flash before feeding.
Cause
Wrong setting of the bar pusher
working position.
Cure
Remedy
Adjust the bar pusher working position.
THE CARRIAGE WON'T COMPLETE ITS PREFEED
STROKE
THE BAR PUSHER WON'T REACH THE REAR
END-OF-STROKE
BAR HAS DIFFICULTIES IN ENTERING LATHE
COLLET
To Next Page
Loading...
