IEMCA VIP 80 - Page 47

USE AND OPERATION
6
302.028
- 44 -
6.8. PERFORMING A “STEP BY STEP” CYCLE
Introduction
This mode can be used for many reasons, as for
instance;
– to check a complete bar change cycle;
– to check the bar feeder mechanics;
– to load a single bar with the intent of checking the
facing;
– eccetera.
Procedure
– Press to start the bar feeder;
– Press to select the semi-automatic cycle;
– Press to select automatic cycle;
– Press , the bar feeder performs the first
step;
– Press , the bar feeder performs the second
step , and so on.