IEMCA VIP 80 - Page 98

36
2
INSTALLATION PROCEDURE
302.061
Turns off the signalling of
parameter 35
in position 1 at every use.
Defines the duration of the CYCLE START signal.
Defines the duration of the CYCLE STOP signal.
During bar change the signal stops the spindle.
0 -
The relay is disabled during bar change.
1 -
The relay remains always enabled.
36
Phase
machining
:>1
no.36 K15 Disabling
37
Phase
machining/bar change
:>2 ( sec)
no.37 K15 time
38
Phase
bar change
:>5 ( sec)
no.38 K13 time
39
Phase
bar change
:>0
no.39 Spindle stop