/ /
Manual Page 111
E.1.2 Operation Info
In the section Device Information click the button Operation Info and the following list
will show various scan counters and elapsed times.
Picture 124: Operation Info screen
The following table gives a brief description.
The total number of scans performed since the scanner left
the factory. Each CCD scan cycle is counted, regardless of
it being a pre-scan or a full scan.
The total number of power up cycles performed since the
scanner left the factory. Only the power-
counted, which were invoked by the on/off button.
The total number of activating the job mode for scanning.
The total operating time since the scanner left the factory.
This is the on-time only, standby time does not count.
The total lamp operating time since the scanner left the
factory.
Time
The typical remaining lifetime of the lamps. With normal
working conditions the lamp life is sufficient for the lifetime
of the device.
To return to the USER screen (Picture 121), click the button Back to Main Menu or click
on the “Return” button in your browser.
Login screen (Picture 120) click the button
Setup Menu
Click the button Launch Scan Application to switch directly to the main screen of the
integrated ScanWizard user interface.
To Next Page
Loading...
Need help?
General
