INIM Prime - Chapter 9 Programming user codes; 9-1 Change user PIN

Programming manual
Programming user codes 53
Chapter 9 Programming user codes
Programming of the user codes involves both the authorizations of the user the code is
associated with, and the code itself with its parameters (hierarchical level, PIN, etc.).
Via softwareClick on the Codes button on the menu on the left, the section on the right will provide a list
of all the available user codes and their parameters. Selecting one of the options will allow you
to configure the parameters of the single code by clicking on the button.
Via keypad Type-in Code (Installer), PROGRAMMING Codes
This section allows you to program the various options of the selected user code.
9-1
Change user PIN
The user code PINs must be numeric and comprise 4 to 6 digits.
In order to be EN50131 compliant, all PINs must have 6 figures.
The PIN of the user code n. 1 is “0001” by default. The successive user cod PINs are “0002”,
“0003” etc., up to “0150” for the Prime060S and Prime060L, up to “0200” for Prime120L, up
to “0300” for Prime240L and up to “0500” for Prime500L.
Via softwareClick on the Codes button on the menu on the left, the section on the right will provide the
“Change User PIN” subsection where you can change the PIN of the selected code.
The new Code PIN can be created in the “New PIN” field in two different ways:
• Old PIN - this way allows you to change an old code PIN (to be entered in the upper
editable field) with a new PIN (to be entered in the lower editable field).
• Master or Manager User PIN - this way, using a Master or Manager user PIN (to be
entered in the upper editable field) allows you to change an old code PIN with a new one
(to be entered in the lower editable field on the right).
Changes will be valid only after the Change PIN button has been pressed.
Via keypad Type-in Code (User) , Change PIN
This section allows you to change the User Code PIN used for access and also the PINs of all
other users with a lower rank in the system hierarchy.
1. Using keys and select the user code you want to change.
2. Type-in the new PIN (4, 5 or 6 digits) using keys , ..., then press OK.
3. Type-in the new PIN again using keys , ..., and press OK to save.
Type in Code (Installer), PROGRAMMING Default settings, Only PIN default
This section will allow you to reset all PINs of the user codes to default.
Via AlienFrom the Alien keypad, access the “Settings” section, enter a valid user code, then access the
“Date/Time - Change PIN - Change tel. num.” section, then the “Change PIN” section.
Select the code you desire from those available on the list. The next step is to change the
code using the buttons on the touch screen then tap OK to confirm.