INIM Prime - Programming IP Parameters

Programming manual
Programming the control panel 31
4-3
Programming IP parameters
Connectivity to the Prime control panel LAN network is subject to the configuration of the
network itself.
It is therefore recommended to contact the network administrator for correct configuration.
Wireless super-
vision time
Parameter for the setting of the wireless-device
monitoring time. On expiration of the set time any
wireless devices that fail to respond will be signalled
as lost.
Accepted values: 12 to 250 minutes.
Other parameters,
Wireless superv.
Mains fault sig-
nal delay
Parameter for the setting of the delay, expressed in
minutes, between an “AC Mains failure” event and
“AC Mains failure” event signalling.
Accepted values: 0 to 250 minutes.
Mains fail.Delay
Low battery
delay
Parameter for the setting of the delay, expressed in
minutes, which will be applied before “LowBattery”
events are actually signalled after detection.
Accepted values: 0 to 250 minutes.
LowBattery delay
BUS speed
Selection of the BUS communication speed (38.4 /
125 / 250 kbps).
Not available
Cloud options
Parameter for selecting the communication channel
with the Cloud:
•Use LAN
•Use Nexus
If both are selected priority will be given to the LAN.
Cloud options
Table 4-3: Control panel options
Table 4-4: IP connection
Parameter Software section
Installer menu sec-
tion
User menu section
IP Address
Subnet mask
Gateway
DNS
Communication
port
Connection parameters
IP connection
parameters,
Connection
parameters
Other parame-
ters,
IP parameters
Settings, IP
Par.and Wi-Fi,
IP parameters
Web server port
SSL port
Not available Not available
Obtain an IP
address auto-
matically
If this option is enabled the above items are not
required. The protocol used is DHCP.
Parameters
Enable DHCP
Parameters
Enable DHCP
Enable UPnP
This option enables UPnP protocol which
automatically activates “port-forwarding” through the
network router of the communication, web and SSL
ports.
Not available Not available
Domain
User name
Password
If you have a dynamic public IP address, you may
find it useful to use a domain name which will allow
you to trace the LAN board at all times.
Prime supports the service offered by:
•dyndns.org
• freedns.afraid.org
• no-ip.com
• camsec.net
•inimdns.biz
By registering at one of these addresses, you will
obtain the access data required in this programming
section:
IP Connection
parameters,
DNS dynamic
Not available Not available
Update every
This interval (expressed in seconds) will be applied by
the LAN when updating the association of the
selected domain with the public IP address.
Not available Not available
Check DDNS
account
This button start the DDNS account verification (for
“inimdns.biz” service only).
Not available Not available
Enable NTP syn-
chronization
If enabled, the Prime control panel clock will be
synchronized with NTP protocol, therefore, it will be
necessary to indicate:
• Server
• Update every - this is the time, expressed in
seconds, that elapses between successive time
updates.
IP connection
parameters,
Configure NTP
client
Not available Not available