INIM Prime - Chapter 2 Programming the control panel; 2-1 Programming via keypad

Programming manual
Programming the control panel 9
Chapter 2 Programming the control panel
The Prime system has been especially designed to be programmed either from a keypad
(using one of the keypads connected to the control panel) or from a PC via Prime/STUDIO
software.
All the parameters of the control panel functions must be programmed by the installer or by
persons qualified by the same.
The control panels are programmed by the manufacturer and leave the factory with almost
ready-to-go settings (“default settings”) that require the installer to implement just a few
“changes” in order to make them operative in the majority of installations. For example, all the
zones, keypads and readers are assigned to partition 1, the alarm and tamper events related
to partition 1 activate the relay output that is programmed as monostable and set with a
monostable time of 3 minutes, etc.
LIMITATIONS The programming of all parameters and data can be done at a keypad or via a PC equipped
with the Prime/STUDIO software with the following limitations.
• From the keypad you cannot program:
•• timer exceptions
•• input calibration
•• BUS speed
•• description of Emergency Keys
•• PrimeLAN board parameters
•• GPRS, GSM and 3G communication parameters
•• Nexus communicator parameters
•• types of sounder tones
•• sounder parameters on I-BUS Ivy-B
•• sounder parameters on the wireless Air2-Hedera
•• programmable events
•• shortcut on event
•• output scenarios
•• configuration of cameras
•• configuration of graphic maps
• via the Prime/STUDIO software you cannot program:
•• DTMF sensitivity
•• the second Installer code
•• the installer code PINs
•• the shortcut descriptions
•• Air2-BS200 transceiver channel
•• calibration of the temperature sensed by a keypad thermometer
2-1
Programming via keypad
Programming of the control panel via one of the Prime system keypads can be carried out
after valid access to the installer menu.
In order to access the installer menu from a keypad and thus have the possibility to read/
write the control panel parameters, it is necessary to:
1. Ensure that all the partitions are disarmed.
2. Type-in the installer code Pin on a keypad then press OK.
When using an Alien keypad, it is necessary to access the “Settings” section, type in the
user code, access the “Installer section” then type-in the installer code.
Note The PIN is “9999” by default.