60 Programming the phone
Anti-intrusion control panels
Chapter
11
Programming the phone
The Prime provides for the programming of all phone parameters, both as regards the phone
numbers to be called when an event occurs and for the phone line parameters.
ATS DEVICE
The integrated ATS device (alarm transmitting system) provides the following features (in
compliance with EN50131 relating to the notification of information).
• Type B notification apparatus (refer to EN50131-1:2008-02, paragraph 8.6 Notification,
Table 10, page 46, Grade 2).
• The ATS2 notification apparatus specified in the table, is characterized by:
•• Transmission time - classification D2 (60 seconds)
•• Transmission time - max. values M2 (120 seconds)
•• Classification time - classification T2 (25 hours)
•• Substitution security - S0 (no detection of device substitution)
•• Information security - I0 (no detection of message substitution)
Via software Clicking on the Telephone button on the menu on the left accesses two sections on the right.
• Telephone numbers, where all the available phone numbers and their parameters are
listed. Selecting one of the options allows you to configure the parameters of the single
scenario by clicking on the button.
• Telephone parameters, where you can configure the parameters of the phone line and
phone dialers.
Via keypad
Type-in Code
(Installer PIN),
PROGRAMMING Telephone
In this section you can program the parameters of each selected phone number as well as
some parameters of the phone line. Other parameters are available in the sections:
Type-in Code
(Installer)
, PROGRAMMING Parameters
or also
Other parameters
11-1
Telephone numbers
Table 11-1: Parameters of single phone number
Parameter Software section Installer menu section
Description
This is an editable field for the code user's phone
number, to be customized by the installer.
Telephone
numbers, selected
number
Telephone, Selected
number, "number"
Telephone num-
ber
Editable field for the contact number (maximum 20
digits).
Accepts also “,” (= 2 second pause), “*” and “#”.
Type
Telephone number type:
• None - the selected number can receive SMS text
messages only
• Voice - the selected number can receive voice
calls and SMS text messages
If the number refers to the Alarm Receiving Centre,
assigns the ARC protocol (reporting format):
• Ademco 10bps, Ademco 14bps, Franklin 20bps,
Radionics 40bps, Scantronic 10bps, CONTACT-ID,
Ademco Express, SIA-IP
Account code
This is the 4-character alphanumeric code which
identifies the caller in reports to the Alarm Receiving
Centre.
To Next Page
Loading...
