Programming manual
Programming user codes 55
In all methods of access (A, B and C), the key allows you to access/view the other cases
in succession, see figure.
9-3
User code parameters
Table 9-2: Single code parameters
Parameter Software section Installer menu section
Description
This is an editable programming field for the code
user's name.
Codes, selected
code
Codes, "code"
Partitions
Section for the selection of the partitions the code is
assigned to.
Type
Programming field for the assignment of the level in
the code hierarchy of the selected user.
The default level of code number 1 is “Master”; the
default level of all the other codes is “User”.
Codes, selected
code, Options
Partition filter
If this option is enabled, the code concerned can
change the parameters only of codes of a lower level
in the code hierarchy whose partitions are a subset of
its own partitions.
For example, if a code is configured as “Master” with
“Partition filter” and is assigned to partitions 1, 3, 5
and 7, it will be able to enable/disable or change the
PIN of a “User” code assigned to partitions 1 and 5 but
not the PIN of a “User” code assigned to partitions 1,
2, and 3.
Codes, "code", Options
Fixed length
If this option is enabled, after entering a valid PIN and
without pressing OK, the user of the code concerned
can activate the shortcut associated with theF12 key,
programmed through the “Shortcuts activated by
function keys” (refer to Table 9-3: Code
enablements).
If this shortcut is number 1 (“Arm/disarm”) and all the
partitions assigned to the user code in question are
disarmed, the command will arm them, otherwise it
will disarm them.
If this option is enabled, the user of the code
concerned can access their menu only after pressing
OK and typing-in their PIN.
Voice guide
If enabled on a keypad with a speaker, the voice guide
(after PIN entry followed by OK) will announce the
shortcut descriptions relating to the entered user-code
and the respective number keys on the keypad.
Codes, selected
code, Enablement
details, Options
AnnounceShortcut
Patrol
If enabled, the code will be a “Patrol” code.
Remote access
If enabled, the code PIN can be used to operate the
system over-the-phone.
Use of an over-the-phone code allows activation only
of the shortcuts associated with phone number keys 0
to 9 and these can be:
•Arm/Disarm
• Stop alarms
• Clear call queue
• Delete memory
•Activate output
•Deactivate output
• Listen-in
•Arming status
Recognized valid
user code
A key is available that directly accesses the
programming section of the system arming event of
the selected code.
Codes, selected
code
Events, Valid Code
To Next Page
Loading...
