56 Programming user codes
Anti-intrusion control panels
9-3-1
Change code PIN
Via software By clicking-on the Codes button in the menu on the left and selecting one of the options, it
will be possible to view the “Change user PIN” subsection in the section on the right.
There are selection checkboxes that allow you to change the PIN of the selected code.
Via keypad The users can change the PINs of the codes they are enabled on:
• activate the “Change PIN” shortcut (shortcut n.34 ), associated with one of the keys ,
..., shown on the display, with or without code entry
• Type-in Code (User), Change PIN
in this way users can change the PINs of the codes they have access to.
Table 9-3: Code enablements
Parameter Software section Installer menu section
Enablements
This section allows you to enable/disable access to the
various sections of the User Menu.
For details regarding the sections of the user menu,
refer to the User Manual.
Codes, selected
code, Enablement
details
Codes, "code"
Enablements
Enablement of
outputs
This section allows you to enable/disable each output
the code is authorized to control manually via the user
menu.
Assigned outputs
Shortcuts acti-
vated via func-
tion keys
In this section you can associate a shortcut (and
eventual parameter) with each of the function
keys(F1, ... , F12) to be activated when the key is
pressed (refer to Appendix B, Shortcuts by default).
Codes, selected
code, Shortcut
details
F1/4KeyShortcuts
Shortcuts acti-
vated by internal
keys
In this section you can associate each number key on
the control panel keypad (0, ... , 9) with a shortcut
(and eventual parameter) to be activated when the
key is pressed.
Key shortcuts
Timers
In this section you can associate a timer to the code
thus allowing the code to operate only at the pre-set
times.
Codes, selected
code, Enablement
details, Options
Timers
To Next Page
Loading...
