Intel Arria 10 FPGA User Manual

5.1. Connecting to the Board Update Portal Web Page
This section provides instructions to connect to the Board Update Portal web page.
Before you proceed, ensure that you have the following:
• A PC with a connection to a working Ethernet port on a DHCP enabled network.
• A separate working Ethernet port connected to the same network for the board.
• The Ethernet cable, power cables, and development board that are included in the
kit.
To connect to the Board Update Portal web page, perform these steps:
1. Install the latest Altera software tools, including the Quartus Prime software, Nios
II processor and IP functions. If necessary, download the Quartus Prime Lite
Edition software.
2. With the board powered down, set SW6.4 to the ON position.
3. Attach the Ethernet cable from the board to your LAN.
4. Power up the board. The board connects to the LAN's gateway router and obtains
an IP address. The LCD on the board will display the IP address.
5. Launch a web browser on the PC that is connected to the same network, and enter
the IP address from the LCD into the browser address bar. The Board Update
Portal web page will appear in the browser.
You can click Arria 10 GX FPGA Development Kit on the Board Update Portal web page
to access the kit’s home page for documentation updates and additional new designs.
You can also navigate directly to the Arria 10 GX FPGA Development Kit page of the
Altera website to determine if you have the latest kit software.
Related Information
• Quartus Prime Software Page
• Arria 10 GX FPGA Development Kit Web Page
5. Board Update Portal
683526 | 2023.07.12
Send Feedback
Intel
®
Arria
®
10 FPGA Development Kit User Guide
53

Intel Arria 10 FPGA Specifications

General

Brand	Intel
Model	Arria 10 FPGA
Category	Microcontrollers
Language	English