Appendix D — Intermec Supplies
166 EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version)
TTR Gloss
Polyethylene
83 25 0 250 250
HR03 TTR High Gloss
Polyester
88 25 0 150 225
1. Exceeding the recommended print speed may cause the printhead to wear out prematurely. If
the ambient temperature is lower than =15°C (+59°F), decrease print speed by 50 mm/sec.
2. Applies to printing of text, lines, boxes, images, and picket fence bar codes.
3. Applies to ladder bar codes.
4. Requires high printhead pressure (See “Printhead Pressure” on page 131).
Thermal Transfer Printing; 8 dots/mm (203.2 dpi) (continued)
Type/Speed Name
Ribbon
Constant
Ribbon
Factor
Label
Offset
Max Rec.
Dir 1&3
2
Print Speed
1
Dir 2&4
3
Direct Thermal Printing; 11.81 dots/mm (300 dpi)
Type/Speed Name
Label
Constant
Label
Factor
Max Rec.
Dir 1&3
2
Print Speed
1
Dir 2&4
3
Top Coated Thermal Top Board
4
96 40 300 200
Standard Thermal Top 92 40 300 200
Thermal IR 96 40 250 200
Non Top Coated Thermal Eco 74 40 300 300
Standard Thermal Eco Board
4
61 40 300 250
Top C o ate d / Hi gh Thermal Top Coated 85 40 300 300
Thermal Transfer Printing; 11.81 dots/mm (300 dpi)
Type/Speed Name
Ribbon
Constant
Ribbon
Factor
Label
Offset
Max Rec.
Dir 1&3
2
Print Speed
1
Dir 2&4
3
GP02 TTR Uncoated 64 25 0 300 300
TTR Coated 63 25 0 300 300
TTR Premium 56 25 0 300 300
HP66 TTR Coated 71 25 0 300 300
TTR Premium 71 25 0 300 300
TTR Premium
Board
4
99 25 0 300 300