Interroll 24-V/48-V Roller Conveyor
RM 8310/8310 DF, RM 8320/8320 DF, RM 8330/8330 DF
Safety
10 Version 1.5 (07/2020) en
Translation of original operating instructions
Dangers
The following list informs you about the various types of danger or damage that may occur
while working with the module.
Safety devices
4 Perform any maintenance and repair work on the module only when it is powered down and
ensure that it cannot be started accidentally.
4 In an area frequented by people or if people can reach between conveying goods,
take additional protective measures.
4 Do not remove protective covers or housing.
4 Regularly check the safety devices.
Heat
4 Do not touch the motor/RollerDrive during operation. Risk of burns.
Electricity
4 Reach into the module only if the module is de-energized.
Rotating parts
4 Never wear loose clothing.
4 Never wear jewelery, such as necklaces or bracelets.
4 If you have long hair, always wear a hair net.
Parts lying around
or falling off
4 Remove equipment or material which is not required from the workspace.
4 Wear safety shoes.
4 Specify and monitor careful placement of the goods on the conveyor.
Risk of injury due to faults
during operation
4 Regularly check the module for visible damage.
4 Stop the module at once and ensure that it cannot be started accidentally in case of:
Smoke from a fire, unusual noise, blocked or defective conveyor belt, defective supports,
side guides or accessory devices, unauthorized removal of safety covers or a defective
suspension.
4 Promptly have qualified personnel determine the cause of the fault.
4 Immediately remove any escaping gear oil.
4 Do not step onto the module during operation.
Maintenance intervals
4 Regularly perform maintenance and inspection work.
4 Use only OEM spare parts.
Interfaces to other devices
New hazardous zones may arise if the module is integrated into a complete system. These zones
are not part of these instructions and have to be analyzed during assembly and startup of the
complete system.
4 When combining the module with other modules or machinery, check for new hazards
before startup. In particular, observe the infeed point at the deflection shaft.
4 If necessary, take further construction measures.
To Next Page
Loading...