Interroll RM 8310 - To be Observed During Installation; Torque; Grounding; Orientation

Interroll 24-V/48-V Roller Conveyor
RM 8310/8310 DF, RM 8320/8320 DF, RM 8330/8330 DF
Installation
Version 1.5 (07/2020) en
Translation of original operating instructions
33
To be observed during installation
Torque
When tightening screws and nuts, always observe the standard tightening torque, unless
specifically indicated otherwise. Standard screw lockers should be replaced as needed.
Grounding
During the installation of the module, its grounding must be observed. Among other things,
the profile connectors are used for this purpose. If no profile connector is used for connecting
the modules, alternate measures must be taken.
Orientation
4 Align the module using the height-adjustable feet of the support. The roller top edge (for
roller conveyors) or the belt top edge (for belt conveyors) is the relevant height for aligning
the modules. Use suitable tools for the alignment (spirit level or rotation laser).
4 Fix the adjusted height.
4 During the alignment of the module, ensure that no moving parts are touching.
Connection
4 Connect the individual modules with each other using the profile connector.
4 During the setup of the module, check the passageways for the personnel. Install transitions
as necessary.
Anchoring
4 Anchor or fasten the module torsion-free, e.g. to the floor or to adjacent components.
Integration into
complete system
4 When integrating the module into the complete system, consider possible danger spots,
particularly infeed locations and interfaces.