Interroll RM 8310 - Operation; Before Every Operation Start; During Operation; Procedure in Case of Accident or Fault

Interroll 24-V/48-V Roller Conveyor
RM 8310/8310 DF, RM 8320/8320 DF, RM 8330/8330 DF
Initial startup and operation
Version 1.5 (07/2020) en
Translation of original operating instructions
53
Operation
Before every
operation start
4 Check the module for visible damage. In particular, observe belt, guides and supports.
4 Ensure that all safety devices operate flawlessly.
4 Ensure that only authorized personnel is in the operating area of the module.
4 Ensure that it is running freely and that no parts are jammed.
4 Remove material or equipment which is not required from the workspace.
4 Guide and monitor correct placement of the materials on the conveyor.
During operation
WARNING
Danger from rotating parts
Crushing and serious injuries from parts of the body and clothing being pulled into the module!
4 Do not remove the protective covers.
4 Wear close-fitting clothing, avoid jewelry and bands/ribbons.
4 If you have long hair, always wear a hair net.
CAUTION
Risk of shearing between product and rollers or product and universal support of
the side guide
4 Do not reach inside from below or from the side.
4 Take additional protective measures.
4 If goods are jammed between side guides, switch off the module and ensure that it cannot be
started accidentally, then remove the fault.
Procedure in case of
accident or fault
4 Stop the module, power it down and ensure that it cannot be started accidentally.
4 In case of an accident: Render first aid and make an emergency call if necessary.
4 Inform qualified personnel.
4 Have the fault removed by qualified personnel.
4 Restart the module only after this has been approved by qualified personnel.