Interroll 24-V/48-V Roller Conveyor
RM 8310/8310 DF, RM 8320/8320 DF, RM 8330/8330 DF
Version 1.5 (07/2020) en
Translation of original operating instructions
55
Maintenance and repair
Observe the following for maintenance and repair
WARNING
Risk of crushing and injuries
4 Ensure that the personnel involved in maintenance and repair have secure footing and
sufficient room to move.
4 Mechanical maintenance and repair work should be performed only by service personnel.
Observe the safety information.
4 Electrical maintenance and repair work should be performed only by authorized electricians.
Observe the safety information.
4 Observe the weight of the module (see nameplate), if necessary work in pairs.
4 Use suitable loading and lifting equipment. Secure the module against falling or tipping.
When tightening screws and nuts, always observe the standard tightening torque, unless
specifically indicated otherwise. Standard screw lockers should be replaced as needed.
Serrated flange bolts and nuts used in elongated holes must have a conical spring washer so
that they can be loosened again if necessary (e.g., for disassembly).
4 Always have work on electrical equipment carried out by authorized electricians.
4 Set up warning signs that indicate maintenance and repair work.
4 Block off the area around the module.
4 Inform persons who must enter the blocked-off area about the risks.
To Next Page
Loading...