Interroll 24-V/48-V Roller Conveyor
RM 8310/8310 DF, RM 8320/8320 DF, RM 8330/8330 DF
Installation
Version 1.5 (07/2020) en
Translation of original operating instructions
43
Requirement:
R The module is shut down.
4 Remove the side frame cover (2) from the side frame.
4 Swing up the cover (7) of the universal support.
4 Loosen hexagon head screws (6) in the universal support, but do not remove them.
4 Insert the clamping plate (3) into the side frame at the rear of the universal support by
slightly turning the support.
4 Position the universal support on the side frame and slightly tighten the two hexagon head
screws in the desired location.
4 Align the mounting bracket (5).
4 Firmly tighten the hexagon head screws.
4 Swing up the cover (7) of the universal support until you hear it snap in.
4 Attach side frame cover. Cut the side frame cover at the locations where the universal
support is installed and shorten it accordingly. Snap in the individual parts of the side frame
cover on the right and left sides of the universal support.
To Next Page
Loading...