Interroll 24-V/48-V Roller Conveyor
RM 8310/8310 DF, RM 8320/8320 DF, RM 8330/8330 DF
Maintenance and repair
80 Version 1.5 (07/2020) en
Translation of original operating instructions
Removing the old finger guard:
4 Remove side frame cover.
4 From the outside of the C-profile, push up the snap-in nose of the finger guard so that the
finger guard pops out.
4 For pitches greater than 60 mm, lift the complete guard between the rollers towards the top
and remove it.
4 For pitches equal to 60 mm, push the bottom part (4) off the top part (3) to be able to
remove the guard. This requires access to the conveyor belt from below.
Installing the new finger guard:
For pitches equal to 60 mm, the finger guard must be installed in two steps.
4 Clip the top part (3) of the finger guard into a pocket hole (2).
4 Push the bottom part (4) of the finger guard onto the top part. This requires access to the
conveyor belt from below.
For pitches greater than 60 mm, the pre-assembled top and bottom parts must be installed as a
complete unit. This requires two complete guards.
4 Each of the two guards must be installed directly adjacent to the rollers.
For pitches greater than 90 mm, a gap is created between two guards.
To Next Page
Loading...