Invacare STORM - REM Remotes: Error Codes and Diagnostic Codes

25
PROBLEM
OTHER
SYMPTOMS
POSSIBLE
CAUSE
SOLUTION
Documentation
Remote shows
blinking "E"
1
or
blink code 2
2
Status diode on
lighting/actuator
module does not
go out even if
the remote has
been switched
off or
disconnected
Lighting /
actuator module
defective
Replace lighting /
actuator module
See chapter Fehler!
Verweisquelle konnte
nicht gefunden werden..
Cable
disconnected or
damaged
Safeguard cable
connection,
replace cable if
necessary
See chapter 8.3.5.
Electrical
adjusting motor
defective
Check adjusting
motor
Electrical
adjustment
motor does
not react
None
Remote
defective
Replace remote
See chapter 8.4.1.
1 Only applies to remote SD24
2 All remotes except SD24