INVT GD200-037G/045P-4 - Page 60

Goodrive200 inverters Function codes
59
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
one again and it lasts for the time set by P01.20,
the inverter will run automatically.
Note: The time is the total value when the set
frequency is above the lower limit one.
Setting range: 0.0~3600.0s
(valid when P01.19=2)
P01.21
Restart
after power
off
This function can enable the inverter start or not
after the power off and then power on.
0: Disable
1: Enable, if the starting need is met, the inverter
will run automatically after waiting for the time
defined by P01.22.
0 ○
P01.22
The
waiting
time of
restart
after power
off
The function determines the waiting time before
the automatic running of the inverter when
powering off and then powering on.
Setting range: 0.0~3600.0s
(valid when P01.21=1)
1.0s ○
P01.23
S
tart delay
time
The function determines the brake release after
the running command is reference, and the
0.0s ○