Goodrive270 series VFD for fan and pump Basic operation guidelines
-90-
37
Switch the running
command channel to
terminal
When the function is enabled, the running command
channel is switched to terminal. When the function is
disabled, the running command channel is restored to the
38
Switch the running
command channel to
communication
When the function is enabled, the running command
channel is switched to communication. When the function
is disabled, the running command channel is restored to
39 Pre-exciting command
When the function is enabled, motor pre-exciting is started
until the function becomes invalid.
40
Clear power consumption
After this command becomes valid, the power consumption
quantity of the VFD will be zeroed out.
41
Keep power consumption
When the function is enabled, the present operation of the
VFD does not impact the power consumption quantity.
42
Switch the setting source
of braking torque upper
The torque upper limit is set through the keypad when the
command is valid.
When the command is valid, PID2 starts.
When the command is valid, PID2 stops.
When the command is valid, PID2 integral is paused.
When the command is valid, PID2 control is paused.
When the command is valid, PID2 polarity is switched.
78
Disable HVAC (only in
When the command is valid, HVAC is disabled (only in
When the command is valid, fire signal is triggered.
When the command is valid, PID1 control is paused.
When the command is valid, PID1 integral is paused.
When the command is valid, PID1 polarity is switched.
When the command is valid, the sleep mode is triggered.
When the command is valid, the wakeup mode is triggered.
When the command is valid, manual polling is enabled.
86 Pump cleaning signal
When the command is valid, pump cleaning signal is
87
Water level upper limit of
When the command is valid, the water level upper limit of
88
Water level lower limit of
When the command is valid, the water level lower limit of
To Next Page
Loading...
Need help?
General
