ITech IT7900 Series

ARB Subsystem
Copyright © ITECH Electronic Co., Ltd. 89
A phase AC voltage ID: 0 (single-phase)
B phase AC voltage ID: 1
C phase AC voltage ID: 2
A phase AC voltage slope ID: 3 (single-phase)
B phase AC voltage slope ID: 4
C phase AC voltage slope ID: 5
A phase DC voltage ID: 6 (single-phase)
B phase DC voltage ID: 7
C phase DC voltage ID: 8
A phase DC voltage slope ID: 9 (single-phase)
B phase DC voltage slope ID: 10
C phase DC voltage slope ID: 11
Phase mode ID: 12 (single-phase)(PHASe|CONTinues)
A Phase start angle ID: 13 (single-phase)
B Phase start angle ID: 14(Reserved)
C Phase start angle ID: 15(Reserved)
A Phase frequency ID: 16 (single-phase)
B Phase frequency ID: 17(Reserved)
C Phase frequency ID: 18(Reserved)
A Phase frequency slope ID: 19 (single-phase)
B Phase frequency slope ID: 20(Reserved)
C Phase frequency slope ID: 21(Reserved)
A Phase waveform type ID: 22 (single-phase)
B Phase waveform type ID: 23
C Phase waveform type ID: 24
Step jump 1 ID: 25 (single-phase)(TIME|TRIGger|PHASe)
Step jump 2 ID: 26 (single-phase)( When Step jump 1 ID is TIME, this
parameter is the time value; when Step jump 1 ID is TRIGger, this parameter can
be IMME/PHASe; when Step jump 1 ID is PHASe, this parameter is the angle
value)
Trigger Pulse ID: 27 (single-phase)(OFF|ON)
BA angle ID 28
BA angle slope ID 29
CA angle ID 30
CA angle slope ID 31
Step jump 3 ID 32 (single-phase)( This parameter is meaningful only when
jump Step jump 1 ID is TRIGger and Step jump 2 ID is PHASe, which is the angle
value)
<string>: This parameter is the corresponding parameter value for the ID
specified by NR2.