SOURce Commands
Copyright © ITECH Electronic Co., Ltd. 43
Query syntax:
ANGLe:STARt? [MAXimum|MINimum|DEFault]
Example
ANGL:STARt 300.0 //Set the starting angle of the present mode to 300.0°.
ANGL:STARt? //Query the starting angle of the present mode.
[SOURce:]ANGLe:STOP[:IMMediate] <NRf+>
Set and query the stop angle in normal mode.
<NRf+>: Stop angle setting value.
Note: the stop angle is only meaningful for phase A in the three-phase mode, and
the angle of phase B/C is set by the angle difference.
Syntax:
ANGLe:STOP[:IMMediate] <NRf+>
Query syntax:
ANGLe:STOP? [MAXimum|MINimum|DEFault]
Example
ANGL:STOP 300.0 //Set the stop angle of the present mode to 300.0°.
ANGL:STOP? //Query the stop angle of the present mode.
[SOURce:]ANGLe:DIFFerence[:IMMediate]
<type>,<NRf+>
This command is used to set and query the angle difference in Normal mode.
<type>: angle difference type information
BA: angle difference between B and A
CA: angle difference between C and A
<NRf+>: angle difference setting value
Note: meaningful in three-phase unbalanced mode.
Syntax:
ANGLe:DIFFerence[:IMMediate] <type>,<NRf+>
Query syntax:
ANGLe:DIFFerence[:IMMediate]? <type>, [MAXimum|MINimum|DEFault]
Example
ANGL:DIFFerence BA,300.0 //Set the angle difference between B and A to
300.0°.
ANGL:DIFFerence? CA //Query the angle difference between C and A.
To Next Page
Loading...
