ITech IT7900 Series

SOURce Commands
Copyright © ITECH Electronic Co., Ltd. 45
PWAV? C //Query the waveform of C phase.
[SOURce:]DIMMing[:STATe] <CPD>[,CH1|CH2|CH3]
This command is used to set and query the dimming function switch.
Syntax:
DIMMing[:STATe] <CPD>[,CH1|CH2|CH3]
Arguments:
0|OFF|1|ON
Query syntax:
DIMMing[:STATe]? [CH1|CH2|CH3]
Returns:
0|1
Example:
DIMMing 1,2 //enable the dimming function of CH2.
DIMMing? 1 //Query the dimming function status of CH1
[SOURce:]DIMMing:EDGE <CPD>[,CH1|CH2|CH3]
This command is used to set and query the dimming edge.
Syntax:
DIMMing:EDGE <CPD>[,CH1|CH2|CH3]
Arguments:
FRONt|BACK
Query syntax:
DIMMing:EDGE? [CH1|CH2|CH3]
Returns:
FRONt|BACK
[SOURce:]DIMMing:PHASe <NRf>[,CH1|CH2|CH3]
This command is used to set and query the dimming phase.
Syntax:
DIMMing:PHASe <NRf>[,CH1|CH2|CH3]
Arguments:
MAXimum|MINimum|DEFault