ITech IT7900 Series Programming Guide

FETCh & MEASure Commands
Copyright © ITECH Electronic Co., Ltd. 62
FETCh[:SCALar]:FREQuency?
MEASure[:SCALar]:FREQuency?
This command is used to read the single-phase frequency value.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:FREQuency? [A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf>…
Example:
FETC[:SCAL]:FREQ?
FETCh[:SCALar]:POWer[:REAL]?
MEASure[:SCALar]:POWer[:REAL]?
This command is used to read the single-phase real power value.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:POWer [:REAL]? [A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf>…
Example:
FETC:POWer?
FETCh[:SCALar]:POWer:APParent?
MEASure[:SCALar]:POWer:APParent?
This command is used to read the single-phase apparent power value.

ITech IT7900 Series Specifications

General

Brand	ITech
Model	IT7900 Series
Category	Power Supply
Language	English