ARB Subsystem
Copyright © ITECH Electronic Co., Ltd. 88
parameter is angle value.
Trig_out: output a trigger signal.
⚫ Single mode/ Reverse mode：
Vac : AC voltage
Vac_slew : AC voltage slope
Vdc : DC voltage
Vdc_slew : DC voltage slope
Phase mode: CONTinues|PHASe
Start: start angle
Frequency : frequency
Frequency_slew : frequency slope
wave : waveform type
Step Jump para1: step jump mode, TIME|TRIGger|PHASe
Step Jump para2: if the para1 is set to TIME, this parameter is time value. If the
para1 is set to TRIGger, this parameter is IMMe or PHASe. And if para1 is set to
PHASe, this parameter is angle value.
Step Jump para3: if para1 is set to TRIGger and para2 is set to PHASe, this
parameter is angle value.
Trig_out: output a trigger signal.
Syntax
[ARB:]LIST:STEP <NR1>,<string>
Query syntax
[ARB:]LIST:STEP? <NR1>
Example
list:step 1,"220,100,0,0,phase,90,100,100,Sine,time,2,0,OFF" //single mode
list:step
1,"22,22,22,10,10,10,0,0,0,10,10,10,60,10,Sine,Sine,Sine,0,0,0,TIME,2,0,OFF"
//three phase
[ARB:]LIST:STEP:ITEM <NR1>,<NR2>,<NRf+>
This command is used to configure and query the phase parameters of a certain
step in the list.
<NR1>: Step index , [1,100]
<NR2>:
Note: The following are all the parameter IDs of the three-phase mode, those
marked with "single-phase" indicate that they can be used to set and query the
corresponding parameter values in the single-phase mode.
To Next Page
Loading...
