ITech IT7900 Series

SCOPe Subsystem
Copyright © ITECH Electronic Co., Ltd. 114
Example
SCOPe:TRIGger:LEVel MIN
SCOPe:TRIGger:SLOPe <CPD>
This command is used to set and query the trigger edge of the oscilloscope.
Syntax
SCOPe:TRIGger:SLOPe <CPD>
Argument
<RiSE|FALL|BOTH>
Query syntax
SCOPe:TRIGger:SLOPe?
Returns
<RiSE|FALL|BOTH>
Example
SCOPe:TRIGger:SLOPe BOTH
SCOPe:TRIGger:MODE <CPD>
This command is used to set and query the trigger mode of the oscilloscope.
Syntax
SCOPe:TRIGger:MODE <CPD>
Argument
<AUTO|NORMal>
Query syntax
SCOPe:TRIGger:MODE?
Returns
<AUTO|NORMal>
Example
SCOPe:TRIGger:MODE AUTO
SCOPe:LINE:SELection <NR1>,<BOOL>
This command is used to set and query the curve displayed by the oscilloscope,
up to 6 curves can be displayed.