ITech IT7900 Series - Chapter7 Measurement Functions; 7.1 Meter Mode

Output Commands
Copyright © ITECH Electronic Co., Ltd. 48
Chapter5 Output Commands
OUTPut[:STATe] <CPD>
This command sets and query the output state of the power supply.
Syntax:
OUTPut[:STATe] <CPD>
Arguments:
0|OFF|1|ON
Query syntax:
OUTPut[:STATe]?
Returns:
0|OFF|1|ON
Example
OUTP ON //Turn on the power output.
OUTPut:PROTection:CLEar
This command is used to clear the protection status.
Syntax:
OUTPut:PROTection:CLEar
Example
OUTP:PROT:CLE
OUTPut:PROTection:WDOG[:STATe] <CPD>
This command enables or disables the state of the communication watchdog.
Syntax:
OUTPut:PROTection:WDOG[:STATe] <CPD>
Arguments:
0|OFF|1|ON
Returns:
0|1