ITech IT7900 Series

SURGesag Subsystem
Copyright © ITECH Electronic Co., Ltd. 104
Chapter15 SURGesag Subsystem
SURGesag:MODE <mode>
This command is used to set and query the surge/trap wave generating mode.
<mode>: surge/trap wave operating mode PERiod|TRIG.
PERiod generates surge/trap wave periodically, TRIG generates surge/trap wave
when triggered.
Syntax
SURGesag:MODE <mode>
Argument
PERiod|TRIG
Query syntax
SURGesag:MODE?
Returns
PERiod|TRIG
Example
SURGesag:MODe PERiod //Set surge/trap wave generating mode to periodic
mode.
SURGesag:MODe? // Query the surge/trap wave generating mode.
SURGesag:PHASe:STARt <NRf+>
This command is used to set and query the initial phase of the surge/trap wave.
<NRf+>: start phase setting value, or start phase MINimum or MAXimum or
DEFault setting.
Syntax
SURGesag:PHASe:STARt <NRf+>
Argument
<NRf+>
Unit
Degree (°)
*RST
0