ITech IT7900 Series - Chapter9 Technical Specifications; 9.1 Main Technical Parameters

FETCh & MEASure Commands
Copyright © ITECH Electronic Co., Ltd. 59
Chapter7 FETCh & MEASure Commands
FETCh[:SCALar]:CURRent[:AC]?
MEASure[:SCALar]:CURRent[:AC]?
This command is used to read the effective value of single-phase current.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:CURRent? [A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf>…
Example:
FETC:CURR? A
FETCh[:SCALar]:CURRent:DC?
MEASure[:SCALar]:CURRent:DC?
This command is used to read the DC component of single-phase current.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:CURRent? [A|B|C|CH1|CH2|CH3]
Arguments:
[A|B|C|CH1|CH2|CH3]
Returns:
<NRf>…
Example:
FETC:CURR:DC?