Operation
Transporting the Machine
90 90
9811-3400-4
Articulation Lock
Transport Position
!MWARNING
Make sure the articulation lock is in the transport
position before you transport the machine. The
articulation lock must also be in the transport position
if you are carrying out daily checks or doing any
maintenance work in the articulation danger zone.
If the articulation lock is not in the transport position
you could be crushed between the two parts of the
chassis.
4-3-5-7
The articulation lock is stowed in the machines toolbox.
The articulation lock must be installed with the machine in
the 'straight ahead' position.
1 Manoeuvre the machine to put the front and rear
wheels in a straight line, then park the machine on
hard, level ground. K
Stopping and Parking the
Machine ( T 71).
2 Remove the articulation lock from the toolbox.
3 Put the articulation lock C in position, then install
pivot-pin A, then pivot-pin B into the articulation lock
as shown.
4 When pivot-pin A is installed, if pivot-pin B will not go
through the holes, turn the steering wheel slightly to
align the holes for pivot-pin B.
Drive Position
!MWARNING
Always make sure the articulation lock has been
removed before attempting to drive the machine. The
machine cannot be steered with the articulation lock
fitted.
16-3-1-4_2
1 Remove the pivot-pins A and B.
2 Put the articulation lock in the toolbox.
812230-2
Fig 59.
To Next Page
Loading...
