Operation
Seat Controls
28 28
9811-3400-4
9 Lumbar Support Adjustment (Option):
Seat Type 1: Operate the two switches 9 until the
lower part of your back is comfortably supported.
Seat Type 2: Turn the knob 9 until the lower part of
your back is comfortably supported.
10 Backrest Extension Height Adjustment (Option):
Move the backrest extension 10 up or down to adjust
its position.
The backrest extension can be removed if necessary.
Console Arm Rest
P4-2030
Introduction
The position of the arm rest can be adjusted to give the
operator a comfortable and supportive position to move
the loader controls.
Up/Down Adjustment
1 Turn the lever A counter-clockwise to loosen the arm
rest.
Note: When the lever A is loosened to adjust the height of
the arm rest B, also move the arm rest forwards and
backwards to adjust its angle.
2 Adjust the height and angle of the arm rest as
necessary.
3 To lock the arm rest in position, tighten the lever A.
Note: To change the locked position of the lever A, push
the centre button and pull the lever out, then move it to the
new position.
806520-1
Fig 15.
To Next Page
Loading...
